蜡烛,蜡烛技术,蜡烛机,酥油蜡烛灌装机,蜡烛模具,灯芯,蜡烛芯,蜡烛厂,莲花蜡烛,无烟蜡烛

蜡烛技术

 找回密码
 立即注册

QQ登录

只需一步,快速开始

搜索
查看: 2404|回复: 0

蜡烛行业ASTM标准简介(英语)

[复制链接]

191

主题

1

好友

749

积分
     

管理员

Rank: 9Rank: 9Rank: 9

发表于 2017-4-22 15:42:50 |显示全部楼层
核心提示:Regulations and Standards in the Global Industry ASTM INTERNATIONAL, formerly the American Society for Testing and Mate

Regulations and Standards in the Global Industry  
  

ASTM INTERNATIONAL, formerly the American Society for Testing and Materials (ASTM), has published five candle standards, three of them specifically addressing fire safety.  A sixth standard establishing fire-safety specifications for candle accessories is under development.  All ASTM standards are copyrighted by ASTM International.  Copies of the actual standards can be purchased from www.astm.org.  The cost is approximately US$30 each.

ASTM F-1972
STANDARD GUIDE FOR TERMINOLOGY RELATING TO CANDLES AND ASSOCIATED ACCESSORY ITEMS

Defines candle terminology including terms such as candle, candle accessory, wax candle, wick, etc.

ASTM F- 2058
STANDARD SPECIFICATIONS FOR CAUTIONARY LABELING FOR CANDLES BURNED IN A HOME

Sets forth the minimum wording, typestyle and design requirements for the warning label that is to be placed on candles.  The standard addresses the three most common causes of accidental candle fires:

Keep burning candle within sight
Keep out of reach of children and pets
Never on or near anything that can catch fire
ASTM F-2179
STANDARD SPECIFICATION FOR ANNEALED SODA-LIME SILICATED GLASS CONTAINERS THAT ARE PRODUCED FOR USE AS CANDLE CONTAINERS

Developed to address concerns over candle fires caused by broken or shattered glass containers, this standard establishes scratch test and temper specifications for the proper annealing of glass containers used for candles, as well as thermal shock differential requirements.

ASTM F-2417
FIRE-SAFETY DESIGN STANDARD

Sets fire prevention measures for the manufacture and design of candles and candle ensembles.  Requirements of the standards are:

Maximum flame height on all candles shall not exceed 3 inches (3.75” for church candles)
A candle placed on an incline of 10 degrees shall not tip over
A candle shall not support ignition at points other than the intended wick or wicks
When a free-standing, tea light, tea light ensemble, votive or filled candle reaches the end of its useful life:
the candle must not exhibit excessive flame height
the candle must not exhibit secondary ignition
the flame must go out
if a filled candle, the container shall not break



蜡烛行业ASTM标准简介GOOGLE翻译版,仅供参考:

法规和标准在全球工业   
  

ASTM国际组织,前身是美国材料与试验协会( ASTM标准) ,已出版了五蜡烛标准,其中三个专门针对消防安全。第六标准建立防火安全规范的蜡烛配件目前正在开发中。所有ASTM标准是受版权保护的ASTM国际组织。副本的实际标准,就可以买到从www.lazhuchang.com 。费用大约是每个30美元。

ASTM标准的F - 1972年
标准指南术语有关的蜡烛和相关配件产品

蜡烛术语定义包括条款,如蜡烛,蜡烛配件,蜡烛,烛芯

ASTM标准的F - 2058
标准规范的警示标签蜡烛燃烧A首页

规定了最低的措辞, typestyle和设计要求的警告标签,应放在蜡烛。标准涉及的三个最常见的原因意外蜡烛火灾:

保持视线内燃烧的蜡烛
保持遥不可及的儿童和宠物
从来没有上或附近的任何可以着火

ASTM标准的F - 2179
标准规范退火苏打石灰矽化玻璃容器生产用作蜡烛容器

制定解决关切蜡烛火灾造成的损坏或破碎的玻璃容器,这一标准规定了从无到有测试和脾气规格为妥善退火玻璃容器用于蜡烛,以及热冲击差别的要求。

ASTM标准的F - 2417
防火安全设计标准

集防火措施的制造和设计的蜡烛和蜡烛歌舞团。要求的标准是:

最高火焰高度对所有的蜡烛,不得超过3英寸( 3.75 “教堂蜡烛
蜡烛放在倾斜10度不得翻倒
蜡烛不得支持点火点以外的打算芯或威克斯
当一个独立的,茶灯,茶灯合奏, votive或填补蜡烛达到使用寿命结束时:
蜡烛绝不能表现出过分的火焰高度
蜡烛不能二次点火展览
火焰必须走出去
如果填补蜡烛,容器不得突破


更多蜡烛资讯,请关注公众号:

QQ图片20170422011442.png





回复

使用道具 举报

*滑块验证:
您需要登录后才可以回帖 登录 | 立即注册

回顶部